Used SCM Sandya 10/S RCS 110 SW 43 inch 2-Head Wide Belt Sander complete with the following:
*230/440 volt, wired 440 volts
* Serial# AE/019744
- First sanding group grooved steel calibrating roller with 180mm (7 in.) diameter
30 hp @ 60 hz main motor sanding at 18 meters per minute
- Second sanding group combination head with 180mm (7 in.) 45 shore grooved rubber finishing roller and finishing platen
One 2 in. pad inserts for sanding platen for solid wood
18 hp @ 60 hz main motor sanding at 18 meters per minute
Machine Standard Options:
- Grooved rubber coated pressure roller in first position for increased panel grip with multiple pieces
- Rubber pressing roller in position 2-3
- 2.5 hp variable speed feed unit. Feed speed is from 15 fpm to 70 fpm
- Automatic conveyor belt tracking
- 2 roller Infeed and outfeed table extensions
- Extra sturdy robotic welded base with top ground for zero reference point
- Control panel with dust proof membrane keyboard
- Automatic Table Positioning Device
- Electronic digital thickness readout of work table position
- Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
- Accurate and reliable electronic tracking of abrasive belt and air jet cleaning device
- Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
- Front and rear emergency stop buttons
Machine Standard Options cont.
- Automatic trouble shooting panel and emergency stop of machine for:
- sanding belt breaking, tensioning, overtracking
- opening of the access door to the operating groups
- absence of compressed air
- overload on main motors
- Amperage meter for main motors allows maximum utilization of available horsepower
- Main disconnect switch with the ability to be locked out by padlock
- In feed flexible steel hold down , and anti kick back plate
- 3/8 in. thick 50 shore, negative profile (waffle style) rubber feed mat
- Working Width 43 “
- Number of Heads Available 2
- Motor HP Available:
First Sanding Group 30 hp
Second Sanding Group 18 hp
Feed Motor 2.5 hp
- Maximum Work piece Thickness 6.25 in.
- Minimum Work piece Length 16 inches
- Abrasive Belt Size 43 in. X 103 in.
- Compressed Air Requirements 5 cfm. @ 80 psi.
- Dust Outlets 2 outlets @ 6.25 in.
- Exhaust Requirements 2400 cfm.
- Power Requirements 127 amps @ 230 Volts
- Approximate Machine Weight 4,000 lbs.